Description
The Wireless Charging - Rectangular Qi - 2cm Material template delivers precision DXF geometry for professional stone fabrication. With dimensions of standard dimensions, this template provides CNC-ready profiles that ensure consistent, repeatable results. Designed for the specialty category, this template streamlines the fabrication process from initial programming through final finishing. Professional shops rely on accurate templates like this to minimize waste and maximize production efficiency across installations.
Related Templates
The Wireless Charging - Rectangular Qi - 2cm Material template delivers precision DXF geometry for professional stone fabrication. With dimensions of standard dimensions, this template provides CNC-ready profiles that ensure consistent, repeatable results. Designed for the specialty category, this template streamlines the fabrication process from initial programming through final finishing. Professional shops rely on accurate templates like this to minimize waste and maximize production efficiency across installations.
Installation Overview
The fabrication process for the Wireless Charging - Rectangular Qi - 2cm Material begins with DXF template verification and material selection. Import the template geometry into your CAM software, setting appropriate tool paths for the specialty specifications. Select diamond tooling rated for the specific stone material being processed. CNC cutting should proceed in stages: roughing passes followed by finishing passes at full depth. Maintain proper coolant flow throughout all machining operations. After all pieces are cut, perform any required edge finishing or polishing operations. Transport pieces to the installation site using appropriate lifting equipment and A-frame racks. On-site, verify cabinet or substrate preparation meets installation requirements. Apply adhesive in the recommended pattern and set pieces beginning with the largest section. Complete all joints with color-matched epoxy. Allow full cure time before loading the installation with fixtures or appliances. Seal all exposed surfaces with an appropriate stone sealer.
CNC Cutting Notes
CNC programming for the Wireless Charging - Rectangular Qi - 2cm Material should account for tool wear compensation, especially on abrasive marble stones. Recommended parameters: spindle speed 4500-6500 RPM, feed rate 35-55 IPM for roughing. The wireless geometry benefits from a two-pass strategy — rough to within 2mm of final profile, then finish at reduced feed rate (15-25 IPM). Use plunge rates no faster than 10 IPM to prevent tool breakage. Monitor vibration levels during cutting; excessive chatter indicates tool wear or incorrect speed/feed settings. Keep backup tooling on hand for production runs exceeding 50 linear feet of edge profile.
Material Compatibility
The Wireless Charging - Rectangular Qi - 2cm Material profile pairs best with medium-to-hard natural stones and engineered materials. Granite is the ideal substrate, offering the hardness needed to maintain the wireless geometry while accepting a brilliant polish. Quartz composites provide consistent results with minimal tool wear variation. For softer stones like marble or limestone, the profile remains achievable but requires adjusted CNC parameters and additional care during finishing. Exotic stones such as quartzite and super-white dolomite produce stunning results with this profile. Sintered stone panels are compatible when using specialized thin-material tooling. Always perform a test cut on representative material before beginning production runs.
Where to Buy
Professional fabricators can source marble slabs from local stone distributors and wholesale suppliers. Visit SlabWise for template downloads and fabrication resources.