Description
Double ogee edge profile for 3cm+2cm laminated (2") countertop slabs. Two stacked S-curves. Optimized polishing parameters for Granite. Standard polishing sequence for natural granite.
Related Templates
Bird's Beak Edge Profile (Granite) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Marble) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Porcelain) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Quartz (Engineered)) - 2cm+2cm Laminated
Fabricators seeking precision for double edge work will find the Double Ogee Edge Profile (Granite) - 3cm+2cm Laminated template indispensable. At standard dimensions, this DXF profile is optimized for CNC router operations across multiple stone types. The geometry accounts for standard tooling clearances and finish passes required in professional countertop fabrication. Whether working with engineered quartz or engineered alternatives, this template ensures uniform results across an entire project. Shop managers appreciate the time savings from eliminating manual layout work, and the double profile remains one of the most requested designs in residential and commercial projects.
Installation Overview
Installing the Double Ogee Edge Profile (Granite) - 3cm+2cm Laminated edge profile requires careful preparation of the substrate edge before applying the profile. Begin by ensuring the countertop slab is cut to final dimensions with clean, squared edges. For engineered quartz substrates, use a diamond blade at reduced feed rates to prevent chipping. The edge profile should be roughed using a CNC router with the DXF template loaded as the toolpath guide. Start with a roughing pass at 60-70% depth using a coarse diamond bit, then follow with a finishing pass at full depth using a fine-grit profile wheel. Allow adequate water flow during cutting to prevent thermal stress fractures. After CNC shaping, hand-finish using progressive diamond polishing pads from 50 grit through 3000 grit. For the double profile specifically, pay attention to the transition zones where curves meet flat surfaces. Apply a stone sealer appropriate for engineered quartz once the edge is fully polished. Final inspection should verify the profile matches the DXF geometry within 1/32" tolerance.
CNC Cutting Notes
CNC programming for the Double Ogee Edge Profile (Granite) - 3cm+2cm Laminated should account for tool wear compensation, especially on abrasive engineered quartz stones. Recommended parameters: spindle speed 4500-6500 RPM, feed rate 35-55 IPM for roughing. The double geometry benefits from a two-pass strategy — rough to within 2mm of final profile, then finish at reduced feed rate (15-25 IPM). Use plunge rates no faster than 10 IPM to prevent tool breakage. Monitor vibration levels during cutting; excessive chatter indicates tool wear or incorrect speed/feed settings. Keep backup tooling on hand for production runs exceeding 50 linear feet of edge profile.
Material Compatibility
The Double Ogee Edge Profile (Granite) - 3cm+2cm Laminated profile pairs best with medium-to-hard natural stones and engineered materials. Granite is the ideal substrate, offering the hardness needed to maintain the double geometry while accepting a brilliant polish. Quartz composites provide consistent results with minimal tool wear variation. For softer stones like marble or limestone, the profile remains achievable but requires adjusted CNC parameters and additional care during finishing. Exotic stones such as quartzite and super-white dolomite produce stunning results with this profile. Sintered stone panels are compatible when using specialized thin-material tooling. Always perform a test cut on representative material before beginning production runs.
Where to Buy
Professional fabricators can source engineered quartz slabs from local stone distributors and wholesale suppliers. Visit SlabWise for template downloads and fabrication resources.