Description
Double ogee edge profile for 2cm (3/4") countertop slabs. Two stacked S-curves. Optimized polishing parameters for Porcelain. Care needed to avoid chipping on porcelain slab edges.
Related Templates
Bird's Beak Edge Profile (Granite) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Marble) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Porcelain) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Quartz (Engineered)) - 2cm+2cm Laminated
The Double Ogee Edge Profile (Porcelain) - 2cm represents a precision-engineered edge profile template built for CNC fabrication workflows. Measuring standard dimensions, this DXF file provides the exact toolpath geometry that professional fabricators need. The double profile is well-suited for marble installations, offering a clean transition that complements modern and traditional designs alike. Experienced fabricators know that starting with an accurate template is the foundation of quality work, and this profile delivers the consistency required for multi-piece installations in hospitality environments.
Installation Overview
The Double Ogee Edge Profile (Porcelain) - 2cm edge fabrication process begins with verifying slab thickness matches the template specifications. Load the DXF profile into your CNC control software, setting the origin point at the slab edge. For marble, select diamond tooling rated for the stone hardness. The roughing sequence should remove material in 3-4 progressive passes to avoid excessive tool wear. Use climb milling direction for cleaner edges on the double profile. Maintain consistent coolant flow throughout all cutting operations. After CNC profiling, inspect the edge against the template geometry using a profile gauge. Hand finishing starts with 50-grit diamond pads, working through the standard progression to 3000 grit. The double profile may require specialty polishing pads for concave sections. Apply masking tape along the countertop surface adjacent to the edge during polishing to prevent surface scratches. Finish with an appropriate stone sealer that penetrates without altering the stone's appearance.
CNC Cutting Notes
Optimal CNC settings for the Double Ogee Edge Profile (Porcelain) - 2cm template depend on the substrate material. For natural granite, use 4000-5500 RPM with 30-50 IPM feed. For quartz composites, increase to 5500-7000 RPM at 45-65 IPM. The double profile requires careful attention to entry and exit points on the toolpath to prevent edge chipping. Program multiple depth passes rather than a single full-depth cut. Coolant temperature should remain below 70°F for optimal diamond tool performance. Dress profiling wheels after every 20-30 linear feet of cutting to maintain profile accuracy.
Material Compatibility
The Double Ogee Edge Profile (Porcelain) - 2cm profile pairs best with medium-to-hard natural stones and engineered materials. Granite is the ideal substrate, offering the hardness needed to maintain the double geometry while accepting a brilliant polish. Quartz composites provide consistent results with minimal tool wear variation. For softer stones like marble or limestone, the profile remains achievable but requires adjusted CNC parameters and additional care during finishing. Exotic stones such as quartzite and super-white dolomite produce stunning results with this profile. Sintered stone panels are compatible when using specialized thin-material tooling. Always perform a test cut on representative material before beginning production runs.
Where to Buy
Professional fabricators can source marble slabs from local stone distributors and wholesale suppliers. Visit SlabWise for template downloads and fabrication resources.