Description
Double ogee edge profile for 2cm+2cm laminated (1-9/16") countertop slabs. Two stacked S-curves. Optimized polishing parameters for Ultracompact (Dekton/Neolith). Diamond tooling required. Higher RPM and starting at coarser grit for sintered surfaces.
Related Templates
Bird's Beak Edge Profile (Granite) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Marble) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Porcelain) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Quartz (Engineered)) - 2cm+2cm Laminated
Designed for professional stone fabrication, the Double Ogee Edge Profile (Ultracompact (Dekton/Neolith)) - 2cm+2cm Laminated template captures the exact geometry needed for flawless double edge profiles. The standard dimensions specifications align with industry-standard tooling and CNC equipment. This profile is particularly suited for engineered quartz countertops where precision matters. From initial roughing passes to final polish, having an accurate DXF template eliminates guesswork and ensures every piece matches. The double edge has proven popular in commercial applications, delivering both durability and visual appeal that clients consistently request.
Installation Overview
Fabricating the Double Ogee Edge Profile (Ultracompact (Dekton/Neolith)) - 2cm+2cm Laminated edge starts with proper slab preparation and CNC setup. Secure the countertop blank on the CNC table using vacuum pods or mechanical clamps, ensuring the edge to be profiled extends beyond the table edge sufficiently. Load the DXF template into your CAM software and set the appropriate tool offsets for your specific edge profiling bits. For the initial roughing pass on engineered quartz, use a feed rate of 40-60 inches per minute with a spindle speed of 4500-6000 RPM. The double profile geometry requires attention to bit selection, using profiling wheels that match the radius specifications in the template. After roughing, perform a semi-finish pass at 80% depth before the final profile cut. Water flow should be maintained at 2-3 gallons per minute minimum to prevent heat buildup. Hand polishing follows CNC work, progressing through 50, 100, 200, 400, 800, 1500, and 3000 grit pads. Buff with a felt pad and polishing compound for a mirror finish. Seal with an impregnating sealer designed for natural stone.
CNC Cutting Notes
CNC programming for the Double Ogee Edge Profile (Ultracompact (Dekton/Neolith)) - 2cm+2cm Laminated should account for tool wear compensation, especially on abrasive engineered quartz stones. Recommended parameters: spindle speed 4500-6500 RPM, feed rate 35-55 IPM for roughing. The double geometry benefits from a two-pass strategy — rough to within 2mm of final profile, then finish at reduced feed rate (15-25 IPM). Use plunge rates no faster than 10 IPM to prevent tool breakage. Monitor vibration levels during cutting; excessive chatter indicates tool wear or incorrect speed/feed settings. Keep backup tooling on hand for production runs exceeding 50 linear feet of edge profile.
Material Compatibility
The Double Ogee Edge Profile (Ultracompact (Dekton/Neolith)) - 2cm+2cm Laminated profile pairs best with medium-to-hard natural stones and engineered materials. Granite is the ideal substrate, offering the hardness needed to maintain the double geometry while accepting a brilliant polish. Quartz composites provide consistent results with minimal tool wear variation. For softer stones like marble or limestone, the profile remains achievable but requires adjusted CNC parameters and additional care during finishing. Exotic stones such as quartzite and super-white dolomite produce stunning results with this profile. Sintered stone panels are compatible when using specialized thin-material tooling. Always perform a test cut on representative material before beginning production runs.
Where to Buy
Professional fabricators can source engineered quartz slabs from local stone distributors and wholesale suppliers. Visit SlabWise for template downloads and fabrication resources.