Description
Cove Dupont edge profile for 2cm+2cm laminated (1-9/16") countertop slabs. Cove at top with straight step below. Optimized polishing parameters for Marble. Lower RPM and starting grit to prevent surface damage on softer marble.
Related Templates
Bird's Beak Edge Profile (Granite) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Marble) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Porcelain) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Quartz (Engineered)) - 2cm+2cm Laminated
The Cove Dupont Edge Profile (Marble) - 2cm+2cm Laminated represents a precision-engineered edge profile template built for CNC fabrication workflows. Measuring standard dimensions, this DXF file provides the exact toolpath geometry that professional fabricators need. The cove profile is well-suited for natural stone installations, offering a clean transition that complements modern and traditional designs alike. Experienced fabricators know that starting with an accurate template is the foundation of quality work, and this profile delivers the consistency required for multi-piece installations in hospitality environments.
Installation Overview
The Cove Dupont Edge Profile (Marble) - 2cm+2cm Laminated edge fabrication process begins with verifying slab thickness matches the template specifications. Load the DXF profile into your CNC control software, setting the origin point at the slab edge. For natural stone, select diamond tooling rated for the stone hardness. The roughing sequence should remove material in 3-4 progressive passes to avoid excessive tool wear. Use climb milling direction for cleaner edges on the cove profile. Maintain consistent coolant flow throughout all cutting operations. After CNC profiling, inspect the edge against the template geometry using a profile gauge. Hand finishing starts with 50-grit diamond pads, working through the standard progression to 3000 grit. The cove profile may require specialty polishing pads for concave sections. Apply masking tape along the countertop surface adjacent to the edge during polishing to prevent surface scratches. Finish with an appropriate stone sealer that penetrates without altering the stone's appearance.
CNC Cutting Notes
For the Cove Dupont Edge Profile (Marble) - 2cm+2cm Laminated profile, set your CNC router spindle speed between 5000-7000 RPM for natural stone substrates. Use a feed rate of 40-60 IPM for roughing passes and reduce to 20-30 IPM for finishing passes. Select a diamond-tipped profile bit matching the template radius specifications. Program the toolpath using climb milling for cleaner cuts on the cove geometry. Maintain coolant flow at 2+ GPM to prevent thermal fracturing. For harder stones like granite, reduce feed rates by 20% and increase water flow. Run a test cut on scrap material to verify the profile matches the DXF template before committing to production stock.
Material Compatibility
The Cove Dupont Edge Profile (Marble) - 2cm+2cm Laminated profile pairs best with medium-to-hard natural stones and engineered materials. Granite is the ideal substrate, offering the hardness needed to maintain the cove geometry while accepting a brilliant polish. Quartz composites provide consistent results with minimal tool wear variation. For softer stones like marble or limestone, the profile remains achievable but requires adjusted CNC parameters and additional care during finishing. Exotic stones such as quartzite and super-white dolomite produce stunning results with this profile. Sintered stone panels are compatible when using specialized thin-material tooling. Always perform a test cut on representative material before beginning production runs.
Where to Buy
Professional fabricators can source natural stone slabs from local stone distributors and wholesale suppliers. Visit SlabWise for template downloads and fabrication resources.