Description
Cove Dupont edge profile for 2cm+2cm laminated (1-9/16") countertop slabs. Cove at top with straight step below. Optimized polishing parameters for Granite. Standard polishing sequence for natural granite.
Related Templates
Bird's Beak Edge Profile (Granite) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Marble) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Porcelain) - 2cm+2cm Laminated
Bird's Beak Edge Profile (Quartz (Engineered)) - 2cm+2cm Laminated
The Cove Dupont Edge Profile (Granite) - 2cm+2cm Laminated profile delivers a refined aesthetic that enhances any countertop installation. With dimensions of standard dimensions, this edge template provides fabricators with precise CNC-ready geometry for consistent, repeatable cuts. Ideal for marble applications, this profile balances visual sophistication with structural integrity. Professional shops rely on standardized DXF templates like this to minimize setup time and reduce material waste during production runs. The cove design works particularly well in hospitality settings where clean lines and polished finishes are expected by discerning clients.
Installation Overview
The Cove Dupont Edge Profile (Granite) - 2cm+2cm Laminated edge fabrication process begins with verifying slab thickness matches the template specifications. Load the DXF profile into your CNC control software, setting the origin point at the slab edge. For marble, select diamond tooling rated for the stone hardness. The roughing sequence should remove material in 3-4 progressive passes to avoid excessive tool wear. Use climb milling direction for cleaner edges on the cove profile. Maintain consistent coolant flow throughout all cutting operations. After CNC profiling, inspect the edge against the template geometry using a profile gauge. Hand finishing starts with 50-grit diamond pads, working through the standard progression to 3000 grit. The cove profile may require specialty polishing pads for concave sections. Apply masking tape along the countertop surface adjacent to the edge during polishing to prevent surface scratches. Finish with an appropriate stone sealer that penetrates without altering the stone's appearance.
CNC Cutting Notes
CNC programming for the Cove Dupont Edge Profile (Granite) - 2cm+2cm Laminated should account for tool wear compensation, especially on abrasive marble stones. Recommended parameters: spindle speed 4500-6500 RPM, feed rate 35-55 IPM for roughing. The cove geometry benefits from a two-pass strategy — rough to within 2mm of final profile, then finish at reduced feed rate (15-25 IPM). Use plunge rates no faster than 10 IPM to prevent tool breakage. Monitor vibration levels during cutting; excessive chatter indicates tool wear or incorrect speed/feed settings. Keep backup tooling on hand for production runs exceeding 50 linear feet of edge profile.
Material Compatibility
The Cove Dupont Edge Profile (Granite) - 2cm+2cm Laminated template works exceptionally well with natural granite, providing clean edges that polish to a high gloss. Marble is also compatible, though the softer stone requires reduced feed rates during CNC operations to prevent micro-chipping. Quartzite offers excellent results with this profile, as the hard mineral structure holds fine details well. Engineered quartz composites are ideal substrates, offering consistent material properties that produce predictable results. Soapstone and slate can be profiled using this template with appropriate tooling adjustments. For limestone, use conservative CNC parameters due to the stone's tendency to chip on detailed profiles. Porcelain sintered stone panels require specialized diamond tooling but produce excellent results with the cove geometry.
Where to Buy
Professional fabricators can source marble slabs from local stone distributors and wholesale suppliers. Visit SlabWise for template downloads and fabrication resources.