Description
The L-Shape Kitchen L with Curved Island - 10x7 is a precision layout template engineered for l-shape countertop fabrication projects. At 25.5" depth, this design addresses the specific requirements of kitchen l shape installations with accurate geometry for CNC-based production. Fabricators benefit from standardized dimensions that reduce setup time and improve consistency across multiple installations. This template represents proven configurations used daily in professional stone fabrication shops.
Dimensions
- Overall Depth
- 25.5"
Specifications
- Downloads
- 0
Related Templates
L-Shape Kitchen L with Angled Corner 45deg - 10x7
L-Shape Kitchen L with Angled Corner 45deg - 10x8
L-Shape Kitchen L with Angled Corner 45deg - 11x8
L-Shape Kitchen L with Angled Corner 45deg - 11x9
The L-Shape Kitchen L with Curved Island - 10x7 is a precision layout template engineered for l-shape countertop fabrication projects. At 25.5" depth, this design addresses the specific requirements of kitchen l shape installations with accurate geometry for CNC-based production. Fabricators benefit from standardized dimensions that reduce setup time and improve consistency across multiple installations. This template represents proven configurations used daily in professional stone fabrication shops.
Installation Overview
Installing the L-Shape Kitchen L with Curved Island - 10x7 countertop layout begins with thorough field measurement verification. Compare the DXF template dimensions against the actual cabinet configuration, noting any deviations. For kitchen l shape installations, ensure all base cabinets are level within 1/8" across the full span. Transfer the template geometry to the stone slab using CNC programming software, optimizing material placement for minimal waste. Cut primary pieces first, followed by any seam sections. For l-shape configurations, plan seam locations at areas of minimum stress and maximum visual concealment. During installation, apply adhesive to the cabinet tops using a continuous bead pattern. Position the first section and check for level before proceeding. Joint seams using color-matched epoxy, clamping pieces together with seam setters. Allow full cure time before removing clamps. Apply supports beneath any overhanging sections exceeding 6 inches. Finish by sealing all surfaces and edges with an appropriate stone sealer.
CNC Cutting Notes
CNC programming for the L-Shape Kitchen L with Curved Island - 10x7 should account for tool wear compensation, especially on abrasive quartzite stones. Recommended parameters: spindle speed 4500-6500 RPM, feed rate 35-55 IPM for roughing. The l-shape geometry benefits from a two-pass strategy — rough to within 2mm of final profile, then finish at reduced feed rate (15-25 IPM). Use plunge rates no faster than 10 IPM to prevent tool breakage. Monitor vibration levels during cutting; excessive chatter indicates tool wear or incorrect speed/feed settings. Keep backup tooling on hand for production runs exceeding 50 linear feet of edge profile.
Material Compatibility
This l-shape profile is compatible with a wide range of countertop materials. Natural granite remains the most popular substrate, offering durability and an attractive polished finish. Engineered quartz performs excellently, with consistent material properties that make CNC cutting predictable and efficient. Marble requires more careful handling — reduce feed rates by 15-20% to prevent veining from causing unpredictable fractures. Quartzite is an excellent choice for this profile, as the material's hardness preserves fine geometric details through years of use. Dolomite and travertine can be profiled with adjusted parameters. Avoid ultra-thin porcelain slabs for complex profiles without proper backing support.
Where to Buy
Professional fabricators can source quartzite slabs from local stone distributors and wholesale suppliers. Visit SlabWise for template downloads and fabrication resources.