Description
The Single Vanity 25"x22" Standard is a precision layout template engineered for single-vanity countertop fabrication projects. At 25" width, 22" depth, this design addresses the specific requirements of bathroom single vanity extended installations with accurate geometry for CNC-based production. Fabricators benefit from standardized dimensions that reduce setup time and improve consistency across multiple installations. This template represents proven configurations used daily in professional stone fabrication shops.
Dimensions
- Overall Width
- 25"
- Overall Depth
- 22"
Specifications
- Downloads
- 0
Related Templates
The Single Vanity 25"x22" Standard is a precision layout template engineered for single-vanity countertop fabrication projects. At 25" width, 22" depth, this design addresses the specific requirements of bathroom single vanity extended installations with accurate geometry for CNC-based production. Fabricators benefit from standardized dimensions that reduce setup time and improve consistency across multiple installations. This template represents proven configurations used daily in professional stone fabrication shops.
Installation Overview
Installing the Single Vanity 25"x22" Standard countertop layout begins with thorough field measurement verification. Compare the DXF template dimensions against the actual cabinet configuration, noting any deviations. For bathroom single vanity extended installations, ensure all base cabinets are level within 1/8" across the full span. Transfer the template geometry to the stone slab using CNC programming software, optimizing material placement for minimal waste. Cut primary pieces first, followed by any seam sections. For single-vanity configurations, plan seam locations at areas of minimum stress and maximum visual concealment. During installation, apply adhesive to the cabinet tops using a continuous bead pattern. Position the first section and check for level before proceeding. Joint seams using color-matched epoxy, clamping pieces together with seam setters. Allow full cure time before removing clamps. Apply supports beneath any overhanging sections exceeding 6 inches. Finish by sealing all surfaces and edges with an appropriate stone sealer.
CNC Cutting Notes
For the Single Vanity 25"x22" Standard profile, set your CNC router spindle speed between 5000-7000 RPM for granite substrates. Use a feed rate of 40-60 IPM for roughing passes and reduce to 20-30 IPM for finishing passes. Select a diamond-tipped profile bit matching the template radius specifications. Program the toolpath using climb milling for cleaner cuts on the single-vanity geometry. Maintain coolant flow at 2+ GPM to prevent thermal fracturing. For harder stones like granite, reduce feed rates by 20% and increase water flow. Run a test cut on scrap material to verify the profile matches the DXF template before committing to production stock.
Material Compatibility
The Single Vanity 25"x22" Standard profile pairs best with medium-to-hard natural stones and engineered materials. Granite is the ideal substrate, offering the hardness needed to maintain the single-vanity geometry while accepting a brilliant polish. Quartz composites provide consistent results with minimal tool wear variation. For softer stones like marble or limestone, the profile remains achievable but requires adjusted CNC parameters and additional care during finishing. Exotic stones such as quartzite and super-white dolomite produce stunning results with this profile. Sintered stone panels are compatible when using specialized thin-material tooling. Always perform a test cut on representative material before beginning production runs.
Where to Buy
Professional fabricators can source granite slabs from local stone distributors and wholesale suppliers. Visit SlabWise for template downloads and fabrication resources.