Description
The Bar Waterfall End Bar - 8ft is a precision layout template engineered for waterfall-end countertop fabrication projects. At 96" width, 18.0" front_depth, this design addresses the specific requirements of bar counter installations with accurate geometry for CNC-based production. Fabricators benefit from standardized dimensions that reduce setup time and improve consistency across multiple installations. This template represents proven configurations used daily in professional stone fabrication shops.
Dimensions
- Overall Width
- 96"
Specifications
- Downloads
- 0
Related Templates
The Bar Waterfall End Bar - 8ft is a precision layout template engineered for waterfall-end countertop fabrication projects. At 96" width, 18.0" front_depth, this design addresses the specific requirements of bar counter installations with accurate geometry for CNC-based production. Fabricators benefit from standardized dimensions that reduce setup time and improve consistency across multiple installations. This template represents proven configurations used daily in professional stone fabrication shops.
Installation Overview
Fabricating and installing the Bar Waterfall End Bar - 8ft layout follows a structured process designed for waterfall-end configurations. Begin by importing the DXF template into your CAM software and creating an optimized cutting plan for 96" width, 18.0" front_depth geometry. For bar counter installations, account for any field modifications noted during site verification. Program CNC cuts with appropriate tool compensation for blade kerf width. Cut all pieces, then perform edge finishing as specified. Dry-assemble the complete layout in the shop when possible to verify fit before delivery. During installation, start with the longest run of the waterfall-end layout, setting it level on the prepared cabinets. Use construction adhesive rated for stone on all cabinet contact surfaces. Proceed with adjoining sections, seaming with color-matched epoxy. For corners in the waterfall-end configuration, use specialized seam placement to minimize visual impact. Support all overhangs with brackets rated for the stone weight. Seal all surfaces upon completion.
CNC Cutting Notes
Optimal CNC settings for the Bar Waterfall End Bar - 8ft template depend on the substrate material. For natural granite, use 4000-5500 RPM with 30-50 IPM feed. For quartz composites, increase to 5500-7000 RPM at 45-65 IPM. The waterfall-end profile requires careful attention to entry and exit points on the toolpath to prevent edge chipping. Program multiple depth passes rather than a single full-depth cut. Coolant temperature should remain below 70°F for optimal diamond tool performance. Dress profiling wheels after every 20-30 linear feet of cutting to maintain profile accuracy.
Material Compatibility
The Bar Waterfall End Bar - 8ft profile pairs best with medium-to-hard natural stones and engineered materials. Granite is the ideal substrate, offering the hardness needed to maintain the waterfall-end geometry while accepting a brilliant polish. Quartz composites provide consistent results with minimal tool wear variation. For softer stones like marble or limestone, the profile remains achievable but requires adjusted CNC parameters and additional care during finishing. Exotic stones such as quartzite and super-white dolomite produce stunning results with this profile. Sintered stone panels are compatible when using specialized thin-material tooling. Always perform a test cut on representative material before beginning production runs.
Where to Buy
Professional fabricators can source granite slabs from local stone distributors and wholesale suppliers. Visit SlabWise for template downloads and fabrication resources.